Energy UNITS FOR LIFT TABLE 1
Standard Description
This electrical power unit is made solely for that small lift table,Consisting of substantial stress gear pump, AC motor, multi-functional manifold, valves, tank, and so forth. This electrical power unit is broadly utilized inside the sector of logistic devices including minifork lift, scissors lift and ariel operating platforms. The lower-ing motion is managed through the solenoid valve with all the speed controlled by the adjustable needle valve.
Electrical power UNITS FOR LIFT TABLE two
Basic Description
This power unit is made solely for that medium lift table, Consisting of really effecient gear pump, AC motor, multifunctional manifold, valves, tank, ect. The reducing motion is actived by the solenoid valve and also the velocity managed by the adjustable needle valve. Once the lift rises to a high positoin, however the power provide is cut, the reducing motion is managed by the guide override function.
Electrical power UNITS FOR LIFT TABLE 3
General Description
This power unit is developed solely for that large lift table, Consisting of highly effecient gear pump, AC motor, multi-functional manifold, valves, tank, ect. The lowering motion is actived from the solenoid valve and the speed managed by a strain compensated flow manage valve.
Power UNITS FOR LIFT TABLE four
Standard Description
This electrical power unit is intended solely to the substantial lift table, Consisting of really effecient gear pump, AC motor, multi-functional manifold, valves, tank, ect. The lowering motion is actived from the solenoid valve as well as velocity managed through the adjustable needle valve. When the lift rises to a large positoin, but the power supply is minimize, the decreasing movement is managed through the guide override function.
Distinctive Notes
one. This energy unit is of S3 duty cycle, which might only work intermittently and repeatedly, i.e. 1 minute on and 9 minutes off.
two. Clean all the hydraulic elements concerned before set up of the electrical power unit.
3. Viscosity of your oil shoud be 15~46 cst,which really should also be clean and absolutely free of impurities.N46 hydraulic oil is recommended.
four. Oil modifying is required following the preliminary one hundred operation hrs,afterwards the moment just about every 3000 hours.
5. The energy unit shown is intended to be mounted vertically.