SMR Gearbox Set up
Satisfactory overall performance will depend on appropriate set up. lubrication and maintenance. thus it is necessary the guidelines during the installation and servicing leaflet. supplied with every gearbox. are followed cautiously. a number of the critical facets of belt and torque-arm installation are listed below.
1. Install pulley on gearbox input shaft as near for the reducer possible, and mount reducer on driven shaft as near to bearing as useful. failure to complete this can result in excess loads during the input shaft bearings and output bearings and could cause their premature failure.
2. Install motor and wedge belt drive with the belt pull at approximately 90° to your center line involving driven and input shafts. this will likely permit 
tensioning on the wedge belt drive with all the torque arm which should really preferably be in tension. if output hub runs anti-clockwise. torque arm need to be positioned the correct.
three. lnstall torque-arm fulcrum on the rigid support to ensure the torque-arm are going to be at roughly ideal angles to your center line through the driven shaft as well as the torque arm situation bolt. make sure there may be enough take up while in the turnbuckle for belt stress adjustment.
Keep shut.
Bell drive may be found in any easy postion. when the torque arm should be to be used to tighten the belts, the drive need to be at about tight angle towards the line in between the input and output shafts.
Bell drive can be located for the proper if preferred.
If output hub rotates clock-wise. place belt drive and torque arm in opposite course to that shown while in the illustration.
Torque arm and belt consider up.
Torque arm could possibly be mounted to your ideal if preferred.
