TF Sort Flanges
Model TF flanges are produced from precisely the same high-strength cast iron since the S flanges, but are intended to accommodate the 
worldwide standard Taper Lock bushing for straightforward installation and elimination
TF Variety flanges let for mounting the bushing on the front (hub) side on the flange
TF flanges can be found in sizes six as a result of sixteen and will be utilized with any style of sleeve as pictured on webpage SF-5
TR Style Flanges
TR flanges are comparable on the TF style, but let for the Taper Lock Bushing for being mounted and removed from
the reverse or serration side on the flange
The constrained torque ratings on the Taper Lock Bushings allow TR flanges to only be applied with EPDM or Neoprene sleeves
Different bushing sizes are applied, so they have different maximum bores than the TF flanges
Sizes six as a result of 16 are available
Taper-Lock Bushings
The business typical taper lock bushing can be a split design allowing a compression match of your flange towards the shaft without having set screws
The easy style and design can make the set up and elimination quick even though the 8° taper grips tight and delivers fantastic concentricity
A Reduced degree of stock is usually attained as a consequence of the numerous other power transmission parts that use Taper Lock Bushings like: sheaves, sprockets, and pulleys
doesn’t give the Taper-Lock Bushings themselves as they’re widely out there from other manufacturers
